Description: SPDH Calibration Home Position Sensor Failure RAP 305-959-00 The calibration home position sensor does not sense the home position after the read motor drives the calibration mechanism to the home position.
Remedy: Remove the SPDH rear cover (5 screws). Observe the calibration home position sensor and the sensor flag. Enter dC330 code 005-360, calibration home position sensor, Q05-360. Actuate the sensor by rotating the exit jam clearance knob, PL 5.17 Item 5 and observing the position of the flag. The display changes. Y↓N→Go to Flag 1. Check Q05-360. Refer to: • • GP 11 How to Check a Sensor • P/J464, SPDH PWB • 301D +3.3V Distribution RAP • 301B 0V Distribution RAP Install new components as necessary: • Calibration home position sensor, PL 5.18 Item 9 • SPDH PWB, PL 5.10 Item 5 Enter dC330 code 005-430 to run the read motor in reverse to drive the calibration shutter mechanism, MOT05-030. MOT05-030 runs and the exit jam clearance knob turns in a clockwise direction. Y↓N→MOT05-030 runs but the jam clearance knob remains stationary. Y↓N→Go to Flag 2. Check MOT05-030. Refer to: • • GP 10 How to Check a Motor • P/J468, SPDH PWB • 301G +24V Distribution RAP • 301B 0V Distribution RAP Install new components as necessary: • Read motor, PL 5.18 Item 1 • SPDH PWB, PL 5.10 Item 5 Check the drive components between the read motor and the calibration mechanism. Install new parts as necessary: • Read motor belt, PL 5.19 Item 18 • Mid scan drive belt, PL 5.19 Item 21 • Exit roll drive pulley, PL 5.19 Item 12 • Calibration shutter drive gear, PL 5.19 Item 10 • Calibration shutter idler gear, PL 5.19 Item 7 • Calibration shutter driven gear, PL 5.19 Item 8 Check the calibration shutter mechanism. repair any damaged parts if possible, if necessary install a new SPDH, PL 5.10 Item 9.