Description: LVF BM Poor Stacking RAP Use this RAP to find the cause of poor stacking in the LVF BM.
Remedy: Check the following; • Look for sets that are not dropping back fully in bin 1 and therefore not operating the bin 1 level sensors: – Large paper sizes should not be stacked on top of small paper sizes. – Ensure that the paper stack in each paper tray has been fanned. – Turn over the paper stack in each paper tray. – Ensure that all paper or other copy stock being used is within the size and weight specifications. Refer to GP 20 Paper and Media Size Specifications. – Try using a fresh ream of paper. – Ensure that the edge guides of all paper trays are adjusted correctly for the paper size and that the trays are fully closed. – Check that bin 1 is seated correctly and the bin 1 alignment clip is in position, PL 11.50 Item 12. • Labels must not be fed to bin 1, but to bin 0 only. • It is recommended that transparencies are fed to bin 0 whenever possible. • Check that bin 1 is level front to back, if necessary perform ADJ 11.1-150 LVF BM Bin 1 Level. • Check that the bin 1 upper level sensor, Q11-332 and the bin 1 lower level sensor, Q11- 333 are working correctly. Refer to the 311-030-00-150, 311-334-00-150, 311-335-00- 150, 311-336-00-150 LVF BM Bin 1 Movement Failure RAP. • Check the operation of the front and rear tampers. Refer to the 311-005-00-150, 311-006- 00-150, 311-311-00-150 LVF BM Front Tamper Move Failure RAP and 311-319-00-150 LVF BM Rear Tamper Move Failure RAP. • Check that the LVF BM is not near an air conditioning or ventilation output duct. Air flow across the output bins can cause poor stacking. • Check the output copies/prints for curl, refer to the IQ5 Print Damage RAP.