Description: Mis-Registration in Stapled and Unstapled Sets RAP Use this RAP to identify and correct the causes of mis-registration in stapled sets, resulting in staples missing some sheets in the set, or poorly registered non-stapled sets.
Remedy: A probable cause of mis-registration is the condition of the paper and/or damage such as, curl, wrinkle, creases, dog ears, etc. • Curl, wrinkle and creases are probably caused in the IOT, go to the IQ1 Image Quality Entry RAP. • For other copy / print damage and dog ears, go to the 311E-171 Copy Damage in the HVF BM RAP. Check the following: • Check the alignment between the IOT and the HVF BM, ADJ 11.1-171. • Turn over the paper stack in the tray in use. • Use a new ream of paper in the tray in use. • Paper type, especially recycled paper, can lead to registration problems. Try changing to a different brand or type of paper. • Ensure that the guides in the paper trays are correctly set and reported on the UI for the paper size loaded, refer to the 371B Tray 1 and 2 Wrong Size Paper RAP. • Check that paper type is set correctly. If heavyweight paper is used but not set in the UI, the compiler capacity can be exceeded. • Check for obstructions in the compiler. • Ensure the paddle roll mechanism in the eject housing operating correctly, refer to the 311-024-00-171, 311-026-00-171 Paddle Roll Position RAP. • Make sure that the compiler carriage tampers move to the correct paper size. • Make sure that the BM tampers move to the correct paper size, refer to 311-066-00-171, 311-384-00-171 HVF BM Tamper Failure RAP. • Check if the HVF module has had the W/TAG V-006 modifications installed. If necessary perform ADJ 11.13-171 HVF Performance Improvement (W/TAG V-006).