Description: Lead Edge Late to Tray 3 Exit Sensor RAP 381-131-00 The lead edge of the paper is late to the tray 3 exit sensor.
Remedy: NOTE: The front door interlock must be cheated when checking +24V components. Enter dC330 code 081-109 tray 3 exit sensor, Q81-109. Press Start. Manually actuate the sensor using white paper. The display changes. Y↓N→Go to Flag 1. Check Q81-109. Refer to: • GP 11 How to Check a Sensor. • P/J19, HCF control PWB. • 301E +5V Distribution RAP. • 301B 0V Distribution RAP. Install new components as necessary: • Tray 3 exit sensor, PL 80.32 Item 6. • HCF control PWB, PL 70.21 Item 2. CAUTION To prevent damage to the feed mechanism, the paper tray must be pulled out before MOT81- 030 is run in service mode. Enter dC330 code 081-030 tray 3 feed motor, MOT81-030. Pull out the tray. Press Start. The motor runs. Y↓N→Go to Flag 3. Check MOT81-030. Refer to: • GP 10 How to Check a Motor. • P/J4, HCF control PWB. • 301G +24V Distribution RAP. • 301B 0V Distribution RAP. Install new components as necessary: • Tray 3 feed motor, PL 80.32 Item 11. • HCF control PWB, PL 70.21 Item 2. Locate the tray 3 feed clutch, CL81-033.. Enter dC330 code 081-030 tray 3 feed motor, MOT81-030, stack the code 081-033 tray 3 feed clutch, CL81-033. Pull out tray 3. Observe the tray 3 feed and nudger rolls. Press Start. The rolls rotate. Y↓N→Go to Flag 3. Check CL81-033. Refer to: • GP 12 How to Check a Solenoid or Clutch. • P/J4, HCF control PWB. • 301G +24V Distribution RAP. • 301B 0V Distribution RAP. Install new components as necessary: • Tray 3 paper feed assembly, PL 80.32 Item 1. • HCF control PWB, PL 70.21 Item 2. Perform the following: • Clean the feed roll, nudger roll and retard roll using a cloth dampened with water. • Check the feed roll, nudger roll and retard roll for wear. If necessary install a new feed roll kit, PL 31.13 Item 14.