Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 311B-171 — Xerox WorkCentre 5890

Code: 311B-171

Description: HVF BM to Machine Communications Interface and BM Present RAP A communication fault exists between the HVF BM and the machine. A UI message System Error or Finisher Comms Failure may be seen.
Remedy: Observe the software heartbeat LED (LED 3) on the HVF control PWB. LED 3 is flashing at 1Hz (0.5 seconds on, 0.5 seconds off). Y↓N→LED 3 is flashing at 0.25Hz (2 seconds on, 2 seconds off) this indicates that the finisher software is corrupt. Re-load the finisher software, GP 4. If necessary install a new HCF control PWB, PL 11.157 Item 2. Observe the software heartbeat LED (LED 1) on the BM PWB. LED 1 is flashing at 1Hz (0.5 seconds on, 0.5 seconds off). Y↓N→LED 1 is flashing at 0.25Hz (2 seconds on, 2 seconds off) this indicates that the booklet maker software is corrupt. Re-load the finisher software, GP 4. If necessary install a new BM PWB, PL 11.166 Item 10. Go to Flag 1, check the wiring and connectors between P/J562and P/J133. The wiring and connectors are good. Y↓N→Repair the wiring or connectors. Go to Flag 2, check the wiring and connectors between P/J121and P/J11. The wiring and connectors are good. Y↓N→Repair the wiring or connectors. The UI indicates that the booklet maker is present (booklet maker options are available). Y↓N→Check that P/J133, pin 6 is held at 0V. If necessary, repair the wiring or install a new HCF control PWB, PL 11.157 Item 2. The finisher checks are good. Switch off the machine, then switch on the machine, GP 14. If the fault remains, perform the Forced Altboot Software Loading Procedure, GP 4.

← Xem tất cả mã lỗi Xerox WorkCentre 5890

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie