Description: Bypass Tray RAP Use this RAP to identify and correct problems when using the bypass tray.
Remedy: Enter dC330 code 075-320 bypass empty sensor Q75-320. Press Start. Manually actuate the sensor. The display changes. Y↓N→Go to Flag 2. Check Q75-320. Refer to: • GP 11 How to Check a Sensor. • P/J10, IOT PWB. • 301D +3.3 V Distribution RAP. • 301B 0V Distribution RAP. If necessary, install a new bypass empty sensor, PL 70.30 Item 7. If the fault remains, perform the OF7 IOT PWB Diagnostics RAP. Enter dC140 code 075-601. Move the bypass tray width guide between wide and narrow settings. NOTE: The width sensor is a potentiometer. The arm on the potentiometer is attached to the bypass tray side guide. This gives a variable voltage to indicate the paper width setting. The displayed value changes. Y↓N→Go to Flag 1. Check Q75-601. Refer to: • GP 11 How to Check a Sensor. • P/J10, IOT PWB. • 301D +3.3 V Distribution RAP. • 301B 0V Distribution RAP. If necessary, install a new bypass tray and left hand door assembly, PL 70.30 Item 1. If the fault remains, perform the OF7 IOT PWB Diagnostics RAP. Enter dC330 code 081-050 bypass feed solenoid, SOL81-050. Press Start. The solenoid energized. Y↓N→Go to Flag 3. Check SOL81-050. Refer to: • GP 12 How to Check a Solenoid or Clutch. • P/J10, IOT PWB. • 301G +24 V Distribution RAP. • 301B 0V Distribution RAP. If necessary, install a new bypass feed solenoid, PL 70.30 Item 4. If the fault remains, perform the OF7 IOT PWB Diagnostics RAP. Perform the following: • Ensure that the customer is not filling the tray above the max fill line. • Clean the feed roll and retard pad with a cloth dampened with water. • If necessary, install a new feed roll and retard pad assembly, PL 70.30 Item 21.