Remedy: NOTE: The front door interlock must be cheated when checking +24V components. Enter dC330 code 081-100 wait sensor, Q81-100. Press Start. Manually actuate the wait sensor. The display changes. Y↓N→Go to Flag 1. Check Q81-100. Refer to: • GP 11 How to Check a Sensor. • P/J5, IOT PWB. • 301D +3.3V Distribution RAP. • 301B 0V Distribution RAP. If necessary, install a new wait sensor, PL 80.15 Item 3. If the problem persists, perform the OF7 IOT PWB Diagnostics RAP. Enter dC330 code 081-101 tray 1 feed sensor, Q81-101. Press Start. Open the bypass tray and left door assembly. Manually actuate the sensor. The display changes. Y↓N→Go to Flag 2. Check Q81-101. Refer to: • GP 11 How to Check a Sensor. • P/J276, Tray 1 and 2 control PWB. • 301E +5V Distribution RAP. • 301B 0V Distribution RAP. Install new components as necessary: • Tray 1 feed sensor, PL 70.30 Item 24. • Tray 1 and 2 control PWB, PL 70.10 Item 2. Enter dC330 code 081-025 transport roll drives motor, MOT81-025. Press Start. The motor runs. Y↓N→Go to Flag 3. Check MOT81-025. Refer to: • GP 10 How to Check a Motor. • P/J273, Tray 1 and 2 control PWB. • 301G +24V Distribution RAP. • 301B 0V Distribution RAP. Install new components as necessary: • Transport roll drives motor, PL 80.25 Item 5. • Tray 1 and 2 control PWB, PL 70.10 Item 2. The transport rolls rotate. Y↓N→Refer to GP 7. Check the drive belt and gears, PL 80.25 Item 2 and PL 80.25 Item 3. Refer to GP 7. Check the following, install new components as necessary: • The bearing, shaft and rolls on the transport roll assembly, PL 80.25 Item 8. • The idler rolls in the left door, PL 70.30 Item 2. • The transport drive belt, PL 80.25 Item 2. • The transport rolls for wear, PL 80.25 Item 8.