Description: Paper Entry Jam RAP 312-125-00-150 The lead edge of the sheet was late to the finisher entry sensor. 312-126-00-110 The trail edge of the sheet was late from the finisher entry sensor. 312-199-00-110 The entry sensor detected paper at the start of a job or during a job without the finisher first receiving a paper at IOT exit sensor command.
Remedy: Refer to the 312H-150 Copy Damage in the LVF RAP. Check the items that follow: • If the fault code is 312-199-00, switch off then switch on the machine, GP 14. • LVF PWB DIP switch settings. Refer to 312F-150 LVF PWB and LVF BM PWB DIP Switch Settings RAP. • That the paper tray guides are set to the correct position for the size of paper in the tray. • The paper entry guide assembly, PL 12.350 Item 7, for damage or wear that could cause paper to jam. • ADJ 12.2-150 Machine to LVF BM Alignment. • Horizontal transport assembly, PL 10.15 Item 1, for obstructions. • Feeding performance from a paper tray loaded with a new ream of paper. Procedure Lower the paper entry guide assembly, PL 12.350 Item 7, to access the entry sensor, Q12-077. Enter dC330, code 012-077. Actuate Q12-077. The display changes. Y↓N→Go to Flag 1. Check Q12-077. Refer to: • GP 11, How to Check a Sensor. • P/J304, LVF PWB. • 312D-150 LVF BM Power Distribution RAP. Repair or install new components as necessary: • Entry sensor, PL 12.385 Item 7. • LVF PWB, PL 12.425 Item 8. Check the operation of the horizontal transport assembly, PL 10.15 Item 1. Refer to 310-171- 00 Trail Edge Late from Horizontal Transport Entry Sensor RAP.