Description: Poor Stacking RAP Use this RAP to find the cause of poor stacking in the LVF BM.
Remedy: Check the items that follow; • Look for sets that are not dropping back fully in bin 1 and therefore not operating the bin 1 level sensors: – Large paper sizes should not be stacked on top of small paper sizes. – Ensure that the paper stack in each paper tray has been fanned. – Turn over the paper stack in each paper tray. – Ensure that all paper or other copy stock being used is within the size and weight specifications. Refer to GP 20 Paper and Media Size Specifications. – Use a new ream of paper, if available. – Ensure that the edge guides of all paper trays are adjusted correctly for the paper size and that the trays are fully closed. – Check that bin 1 is seated correctly and the bin 1 alignment clip is in position, PL 12.320 Item 12. • Labels must not be fed to bin 1, but to bin 0 only. • It is recommended that transparencies are fed to bin 0 whenever possible. • Check that bin 1 is level front to back. If necessary perform ADJ 12.1-150 LVF BM Bin 1 Level. • Check that the bin 1 upper level sensor, Q12-188 is working correctly. Refer to the 312- 462-00-150 LVF BM Bin 1 Movement Failure RAP. • Check the operation of the front and rear tampers. Refer to the 312-392-00-150, 312-393- 00-150, 312-394-00-150 LVF BM Front Tamper Move Failure RAP and 312-396-00-150, 312-397-00-150, 312-398-00-150 LVF BM Rear Tamper Move Failure RAP. • Check that the LVF BM is not near an air conditioning or ventilation output duct. Air flow across the output bins can cause poor stacking. • Check the output copies/prints for curl. Refer to the IQ5 Print Damage RAP.