Description: Side 1 Scanning Document Size RAP The side 1 scanner encountered a document that was larger than expected. The side 1 scanner encountered a document of unknown size. The side 1 document size sensors incorrectly determined the size of the document.
Remedy: Check that the input module angle sensor actuator is not damaged. If necessary install a new input module angle sensor actuator, PL 60.20 Item 12. Enter dC330 code 062-301, SPDH angle sensor Q62-301. Actuate Q62-301. The display changes. Y↓N→Go to Flag 1. Check Q62-301. Refer to: • GP 11, How to Check a Sensor. • P/J423, Scanner PWB. • 301D +3.3V Distribution RAP. • 301B 0V Distribution RAP. Install new components as necessary: • SPDH angle sensor, PL 60.20 Item 7. • Scanner PWB, PL 60.20 Item 4. Enter dC330 code 062-019, SPDH platen down sensor, Q62-019. Actuate Q62-019. The display changes. Y↓N→Go to Flag 2. Check Q62-019. Refer to: • GP 11, How to Check a Sensor. • P/J423, Scanner PWB. • 301D +3.3V Distribution RAP. • 301B 0V Distribution RAP. Install new components as necessary: • SPDH platen down sensor, PL 60.20 Item 7. • Scanner PWB, PL 60.20 Item 4. Raise the SPDH. Enter dC330 code 062-251, document size sensor 1, Q62-251. Actuate Q62- 251 by placing a piece of paper on the document glass above the sensor. The display changes. Y↓N→Go to Flag 3. Check Q62-251. Refer to: • GP 11, How to Check a Sensor. • PL 60.20 Item 4, Scanner PWB. • 301E +5V Distribution RAP. • 301B 0V Distribution RAP. Install new components as necessary: • Document size sensor 1, PL 60.20 Item 3. • Scanner PWB, PL 60.20 Item 4. Enter dC330 code 062-253 document size sensor 2, Q62-253. Actuate Q62-253 by placing a piece of paper on the document glass above the sensor. The display changes. Y↓N→Go to Flag 4. Check Q62-253. Refer to: • GP 11, How to Check a Sensor. • PL 60.20 Item 4, Scanner PWB. • 301E +5V Distribution RAP. • 301B 0V Distribution RAP. Install new components as necessary: • Document size sensor 2, PL 60.20 Item 3. • Scanner PWB, PL 60.20 Item 4. Go to Flag 5. Disconnect and check the SBC PWB to scanner PWB data cable, and the connectors P/J411 on the, Scanner PWB and P/J854 on the SBC PWB. The SBC PWB/Scanner PWB data cable and P/J connectors are clean and undamaged. Y↓N→Clean or repair the SBC PWB/scanner PWB data cable or connectors. Install new components as necessary: • SBC PWB/scanner PWB data cable, PL 60.20 Item 22. • Scanner PWB, PL 60.20 Item 4. If the fault persists, perform the 303D SBC PWB Diagnostics RAP. If the fault persists, perform an AltBoot, GP 4.