Description: SPDH Calibration Home Position Sensor Failure RAP 305-959-00 The calibration home position sensor failed to sense the home position after the read motor drove the calibration mechanism to the home position.
Remedy: Remove the SPDH rear cover PL 5.10 Item 1. Observe the calibration home position sensor and the sensor flag. Enter dC330, code 005-360, calibration home position sensor, Q05-360. Actuate Q05-360 by rotating the exit jam clearance knob, PL 5.17 Item 5 and observing the position of the flag. The display changes. Y↓N→Go to Flag 1. Check Q05-360. Refer to: • GP 11 How to Check a Sensor. • P/J464, SPDH PWB. • 301D +3.3V Distribution RAP. • 301B 0V Distribution RAP. Install new components as necessary: • Calibration home position sensor, PL 5.18 Item 9. • SPDH PWB, PL 5.10 Item 5. Enter dC330, code 005-430 to run the read motor, MOT05-030, in reverse to drive the calibration shutter mechanism. The motor runs and the exit jam clearance knob turns in a clockwise direction. Y↓N→The motor runs but the jam clearance knob remains stationary. Y↓N→Go to Flag 2. Check MOT05-030. Refer to: •. • GP 10 How to Check a Motor. • P/J468, SPDH PWB. • 301G +24V Distribution RAP. • 301B 0V Distribution RAP. Install new components as necessary: • Read motor, PL 5.18 Item 1. • SPDH PWB, PL 5.10 Item 5. Check the drive components between the read motor and the calibration mechanism. Install new components as necessary: • Read motor belt, PL 5.19 Item 18. • Mid scan drive belt, PL 5.19 Item 21. • Exit roll drive pulley, PL 5.19 Item 12. • Calibration shutter drive gear, PL 5.19 Item 10. • Calibration shutter idler gear, PL 5.19 Item 7. • Calibration shutter driven gear, PL 5.19 Item 8. Check the calibration shutter mechanism. Repair any damaged components if possible. If necessary install a new SPDH, PL 5.10 Item 9.