Description: Fuser Warm Up Failure RAP 310-330-00 The Initial fuser temperature rise was not achieved within 40 seconds from start of warm up mode. 310-340-00 The temperature reported by each thermistor failed to rise by 10 degrees C within 10 seconds from start of warm up mode when the starting temperature was less than 150 degrees C.
Remedy: Switch off the machine, GP 14. Remove the fuser module. Check the fuser module connector, for continuity between the pins that follow: • Pin 8 and pin 4. • Pin 8 and pin 7. • Pin 8 and pin 9. There is continuity. Y↓N→Install a new fuser module, PL 10.8 Item 1. Install the fuser module. Disconnect P/J650. Go to Flag 2. Check for continuity between pin 1 and pin 3, and between pin 1 and pin 4 at the harness end. There is continuity. Y↓N→Check the fuser connector assembly. If necessary install a new fuser connector assembly, PL 10.8 Item 3. Go to Flag 3. Check the wiring and connectors. Refer to: • P/J764, IOT PWB. • P/J653, LVPS. • 301B 0V Distribution RAP. The wiring and connectors are good. Y↓N→Repair the harness between P/J764 and P/J653. WARNING Take care when measuring AC mains (line) voltage. Electricity can cause death or injury. NOTE: The voltage will be 100% of the ACL voltage when the machine is switched on from cold, and will pulse between 60% and 100% during standby. Connect P/J650. Switch on the machine, GP 24. Go to Flag 2. Check for ACL at P/J650 between pin 1 and pin 3, and between pin 1 and pin 4. ACL is measured. Y↓N→Perform the OF7 IOT PWB Diagnostics RAP. If the fault persists, install a new LVPS, PL 1.10 Item 1. Go to Flag 1. With the fuser cold, check for +3.2V at P/J764 pin A1 and pin A3. +3.2V is available at both pins. Y↓N→Go to Flag 1. Check the wiring and connectors. NOTE: Do not insert the service meter probes into the PJ100 pins from the left door side. This may damage the pins. Access the pins from the wire side of the connector. Refer to: • P/J764, IOT PWB. • PJ100. • 301D +3.3V Distribution RAP. • 301B 0V Distribution RAP. The wiring and connectors are good. Y↓N→As necessary, perform the actions that follow: • Repair the harness between P/J764 and PJ100. • Install a new fuser connector, PL 10.8 Item 3. Perform the OF7 IOT PWB Diagnostics RAP. If the fault persists, install a new fuser module, PL 10.8 Item 1. If the fault persists, install a new fuser module, PL 10.8 Item 1.