Description: Hole Punch Operation Failure RAP 312-043-00-150 The hole punch failed to perform a punch cycle. 312-046-00-150 The hole punch was not at the home position.
Remedy: Go to Flag 5. Check the link between P/J307 pins 10 and 11, LVF PWB. The link is good. Y↓N→Repair the wiring or connector. Enter dC330, code 012-195, punch head present sensor, Q12-195. Actuate Q12- 195. The display changes. Y↓N→Go to Flag 2. Check Q12-195. Refer to: • GP 11 How to Check a Sensor. • P/J307, LVF PWB. • 312D-150 LVF BM Power Distribution RAP. Repair or install new components as necessary: • Punch head home sensor, PL 12.330 Item 1. • LVF PWB, PL 12.425 Item 8. Enter dC330 code 012-194, punch head home sensor, Q12-194. Actuate Q12-194. The display changes. Y↓N→Go to Flag 1. Check Q12-194. Refer to: • GP 11 How to Check a Sensor. • P/J307, LVF PWB. • 312D-150 LVF BM Power Distribution RAP. Repair or install new components as necessary: • Punch head home sensor, PL 12.330 Item 1. • LVF PWB, PL 12.425 Item 8. Enter dC330 code 012-244, punch head run. The punch cycles. Y↓N→Go to Flag 3. Check the hole punch motor, MOT12-243. Refer to: •. • GP 10, How to Check a Motor. • P/J311, LVF PWB. • 312D-150 LVF BM Power Distribution RAP. Repair or install new components as necessary: • Punch head motor assembly, PL 12.330 Item 2. • LVF PWB, PL 12.425 Item 8. NOTE: The chad bin collects the pieces of paper cut out by the hole punch. The chad bin level sensor will not operate if the bin is incorrectly installed. Ensure the chad bin is fully inserted and the lever engages in the slot. Enter dC330, code 012-193, chad bin level sensor, Q12-193. Use a strip of paper to actuate Q12-193. The display changes. Y↓N→Go to Flag 4. Check Q12-193. Refer to: • GP 11 How to Check a Sensor. • P/J307, LVF PWB. • 312D-150 LVF BM Power Distribution RAP. Install new components as necessary. • Chad bin level sensor, PL 12.330 Item 7. • LVF PWB, PL 12.425 Item 8. Perform SCP 5 Final Actions.