Description: Trail Edge Late from Registration Sensor RAP 381-152-00 The trail edge of the paper was late from the registration sensor when feeding in simplex mode.
Remedy: Open the left door. Enter dC330 code 010-020, fuser drive motor, MOT10-020. Observe the fuser roll and the pressure roll through the top of the fuser. The fuser rolls turn. Y↓N→Go to Flag 1. Check MOT10-020. Refer to: • GP 10, How to Check a Motor. • P/J761, IOT PWB. • P/J656, LVPS. • 301E +5V and +5VSB Distribution RAP. • 301G +24V Distribution RAP. • 301B 0V Distribution RAP. If necessary, install a new main drive module, PL 40.15 Item 1. If the fault persists, perform the OF7 IOT PWB Diagnostics RAP and 301L LVPS RAP. Enter dC330 code 093-045, print cartridge motor, MOT93-045. Observe the photoreceptor. The photoreceptor turns. Y↓N→Go to Flag 1. Check MOT93-045. Refer to: • GP 10, How to check a Motor. • P/J756, IOT PWB. • P/J656,LVPS. • 301E +5V and +5VSB Distribution RAP. • 301G +24V Distribution RAP. • 301B 0V Distribution RAP. Install new components as necessary: • Main drive module, PL 40.15 Item 1. • Print cartridge, PL 90.17 Item 9. If the fault persists, perform the OF7 IOT PWB Diagnostics RAP and 301L LVPS RAP. Enter dC330 code 082-150, registration sensor, Q82-150. Actuate Q82-150. The display changes. Y↓N→Go to Flag 2. Check Q82-150. Refer to: • GP 11 How to check a Sensor. • P/J762, IOT PWB. • 301E +5V and +5VSB Distribution RAP. • 301B 0V Distribution RAP. If necessary, install a new registration sensor, PL 80.17 Item 7. If the fault persists, perform the OF7 IOT PWB Diagnostics RAP. Enter dC330 code 080-040, registration motor, MOT80-040. The motor runs. Y↓N→Go to Flag 3. Check MOT80-040. Refer to: • GP 10, How to Check a Motor. • P/J762, IOT PWB. • 301G +24V Distribution RAP. • 301B 0V Distribution RAP. If necessary, install a new registration motor, PL 40.15 Item 6. If the fault persists, perform the OF7 IOT PWB Diagnostics RAP. Observe the registration roll, PL 80.17 Item 5. The registration roll turns. Y↓N→Check the registration drive gear, PL 80.17 Item 3. Install new components as necessary. Refer to GP 7 and OF10 Intermittent Fault RAP. Check the components that follow: • Registration nip roll, PL 80.15 Item 4. • Bias transfer roll, PL 80.15 Item 3. • Registration roll, PL 80.17 Item 6. • Track (DTS), PL 90.10 Item 6, from the detack saw to the HVPS. Install new components as necessary. If the fault persists, perform the 381A Paper Feed Retries RAP.