Description: Lead Edge Late to HCF Exit Sensor from Tray 3 RAP 381-159-00 The lead edge of the paper was late to the HCF exit sensor when feeding from tray 3.
Remedy: NOTE: The front door and left door must be closed, or their respective interlock switches must be cheated when checking +24V components. Enter dC330 code 081-108, HCF exit sensor, Q81-108. Manually actuate Q81-108. The display changes. Y↓N→Go to Flag 1. Check Q81-108. Refer to: • GP 11 How to Check a Sensor. • P/J755, IOT PWB. • 301E +5V and +5VSB Distribution RAP. • 301B 0V Distribution RAP. If necessary, install a new HCF exit sensor, PL 80.32 Item 3. If the fault persists, perform the OF7 IOT PWB Diagnostics RAP. Enter dC330 code 081-045, HCF transport motor, MOT81-045. The motor runs. Y↓N→Go to Flag 2. Check MOT81-045. Refer to: • GP 10 How to Check a Motor. • P/J756, IOT PWB. • 301G +24V Distribution RAP. • 301B 0V Distribution RAP. If necessary, install a new HCF transport motor, PL 80.36 Item 13. If the fault persists, perform the OF7 IOT PWB Diagnostics RAP. Observe the takeaway roll, PL 80.36 Item 2 and HCF transport roll, PL 80.33 Item 4. The takeaway and HCF transport rolls rotates. Y↓N→Check the components that follow: • Drive belt, PL 80.36 Item 6. • Drive coupling, PL 80.36 Item 7. • Takeaway roll assembly, PL 80.36 Item 2. • Idler roll assembly, PL 80.32 Item 2. • Transport gear pulley, PL 80.36 Item 12. • HCF transport roll, PL 80.33 Item 4. Install new components as necessary. Perform the 381-136-00 Lead Edge Late to Tray 3 Feed Sensor RAP