Description: Lead Edge Late to Registration Sensor from Tray 1 RAP 381-190-00 The lead edge of the paper was late to the registration sensor when feeding from tray 1.
Remedy: NOTE: The front door and left door must be closed, or their respective interlock switches must be cheated when checking +24V components. Enter dC330 code 082-150, registration sensor, Q82-150. Open the left door assembly. Actuate Q82-150. The display changes. Y↓N→Go to Flag 1. Check Q82-150. Refer to: • GP 11 How to check a Sensor. • P/J763, IOT PWB. • 301E +5V and +5VSB Distribution RAP. • 301B 0V Distribution RAP. If necessary, install a new registration sensor, PL 80.17 Item 7. If the fault persists, perform the OF7 IOT PWB Diagnostics RAP. Enter dC330 code 080-006, TAR/bypass tray motor, MOT80-006. The motor runs. Y↓N→Go to Flag 2. Check MOT80-006. Refer to: • GP 10 How to Check a Motor. • P/J754, IOT PWB. • 301G +24V Distribution RAP. • 301B 0V Distribution RAP. If necessary, install a new TAR/bypass tray motor, PL 80.25 Item 5. If the fault persists, perform the OF7 IOT Diagnostics RAP. Observe the transport rolls, PL 80.25 Item 7. The transport rolls rotate. Y↓N→Check the transport roll drive belt, drive pulley and pulley, PL 80.25. Install new components as necessary: • Transport roll drive belt, PL 80.25 Item 2. • Pulley, PL 80.25 Item 4. • Transport roll bearing, PL 80.25 Item 6. • Transport roll, PL 80.25 Item 7. If the fault persists, perform the 381-106-00 Lead Edge Late to TAR 1 Sensor from Tray 1 RAP.