Remedy: 1. Are the Toner Cartridges installed in the printer Xerox Toner Cartridges? Go to step 2. The customer will need to replace all non-Xerox cartridges with Genuine Xerox cartridges. 2. Inspect the contacts on the CRUM connectors. Are any bent or broken? Repair of replace the connector. Go to Step 3. 3. Disconnect P/J13 on the MCU Board and unlace the harness. Inspect the harness for damage. Is the harness damaged? Repair the harness, then go to step 4. Go to step 4. 4. Disconnect P/J13 on the PWBA MCU. Is the voltage across ground to P/J13-3 on the MCU Board approximately +3.3 VDC? Repair the Harness Assembly DCKR. Go to step 5. 5. Replace the Toner Cartridge (C, M, Y, or K). Does the error persist? 1. SaveNVM to ESS 2. Replace the MCU Board. 3. LoadNVM from ESS Complete.