Code: 026-722, 026-723
Description: USB Memory Write Protect Error / File Path Limit Error The USB Memory is write protected or the file path name is too long.
Causes: • IP Board, PL7.1.9 • MCU Board, PL7.2.2
Remedy: 1. 026-722 - Initialize (format) the USB memory device on a computer with one of the following file formats and attempt to perform the operation again. • Supported file formats: FAT12, FAT16 (FAT), FAT32 Note: - NTFS and software encrypted UDSB devices are not supported. Does the error persist? Contact your designated support center representative. Compete 2. 027-723 - Verify the USB device is fully inserted into the USB port and the USB device is not removed while the printer is accessing the USB device. Does the error persist? Go to step 3. Complete 3. Verify the USB device and the file on the USB device are accessible by the computer. Can the device and file(s) be accessed by the computer? Turn the printer off, unplug the printer from the wall for at least 30s, plug back in and turn on. Attempt the print/scan job again. Format the device in one of the following supported formats - FAT12, FAT16 (FAT), FAT32. Retry accessing the USB device on the computer then attempt the scan or print job again. 4. Does the error persist? Go to step 5. Complete. 5. Reload firmware from www.xerox.com. Does the error persist? Go to step 2. Complete. 6. Replace the IP Board (Phaser 6020/6022 and WorkCentre 6025 MFP, WorkCentre 6027 MFP. Does the error persist? Go to step 4. Complete. 7. 1. SaveNVM to ESS 2. Replace the MCU Board. 3. LoadNVM from ESS Complete.