Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 010-317 — Xerox WorkCentre 6505

Code: 010-317

Description: IOT Fuser Detached
Causes: • Fuser Assy (PL6.1.1) • Fuser Harness Assy (PL6.1.2) • MCU Board (SFP PL8.2.13; MFP PL8.3.6)
Remedy: 1 Reseat the Fuser Assy. Does the error still occur when the power is turned Off and On? Go to step 2. Complete. 2 Remove the Fuser Assy. Check these connections: • Between the MCU Board (P/J17) and Fuser Assy (P/J171). • Between the Fuser Assy (P/J171) and LVPS (P/J47). • Between the LVPS (P/J501 and P/J502) and MCU Board (P/J14 and P/J15). Are these connectors connected properly? Go to step 4. Reconnect connector(s) P/J17, P/J47, P/J171, P/J501, P/J502, P/J14 and/or P/J15 properly, then go to step 3. 3 Does the error still occur when the power is turned Off and On? Go to step 4. Complete. 4 Check the Fuser Harness Assy for continuity. Disconnect J17 from the MCU Board. Disconnect J47 from the LVPS. Is each cable of J17 and J47 <=> P171 continuous? NOTE P171 is attached to the frame. Go to step 5. Replace the Fuser Harness Assy. 5 Check the resistances of Temp. Sensor in the Fuser Assy. Remove the Fuser Assy. Check for 370± 10 kΩ across the following pins of J171 when the fuser is cold. • pin 4 to pin 5 • pin 6 to pin 7 • pin 6 to pin 8 Are the resistances correct?. Replace the LVPS. Then go to step 6. Replace the Fuser Assy. After replacing the Fuser, be sure to reset the Fuser counter. 6 Does the error still occur when the power is turned Off and On? Replace the MCU Board Complete.

← Xem tất cả mã lỗi Xerox WorkCentre 6505

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie