Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 042-326 — Xerox WorkCentre 6505

Code: 042-326

Description: IOT Sub Motor Failure
Causes: • Sub Drive Assembly (PL7.1.1) • MCU Board (SFP PL8.2.13; MFP PL8.3.6) • Sub Motor Harness Assy (PL9.1.8)
Remedy: 1 Does the error still occur when the power is turned Off and On? Go to step 2. Complete. 2 Reseat the Fuser Assy and Imaging Unit. Does the error still occur when the power is turned Off and On? Go to step 3. Complete. 3 In the Printer Diagnostic tests, use Engine Diag > Motor Test > Sub Motor FULL1. Does the Sub Motor function normally? Replace the MCU Board. Go to step 4. 4 Check the connections between the MCU Board and Sub Drive Assembly. Are P/J22 and P/J221 connected correctly? Go to step 6. Reconnect the connector(s) P/ J22 and/or P/ J221 correctly, then go to step 5. 5 Does the error still occur when the power is turned Off and On? Go to step 6. Complete. 6 Check the Sub Motor Harness Assy for continuity. Disconnect J22 from the MCU Board. Disconnect J221 from the Sub Drive Assembly. Is each cable of J22 <=> J221 continuous? Go to step 7. Replace the Sub Motor Harness Assy. 7 Reseat the Sub Drive Assembly. Does the error still occur when the power is turned Off and On? Go to step 8. Complete. 8 Check the power to the Sub Drive Assembly. Disconnect J22 from the MCU Board. Are the voltages across J22-2/J22-4 <=> ground on the MCU Board, about +24 VDC when the interlock switch (Interlock Harness Assy) is pushed? Replace the Sub Drive Assembly. Replace the MCU Board.

← Xem tất cả mã lỗi Xerox WorkCentre 6505

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie