Remedy: 1 Using the Printer Diagnostics, test the operation of the Tray 2 Paper Path Sensor: Engine Diag > Sensor Test > Tray 2 Path Sensor. Does the number on the screen increase by one, when the actuator (Registration Input Actuator) is operated? Replace the MCU Board. Go to step 2. 2 Check the connectors for connection. Check the connections between the Feeder Board and Paper Path Sensor. Are P/J420 and P/J4202 connected correctly? Go to step 3. Reconnect the connector(s) P/ J420 and/or P/J4202 correctly. 3 Check the Tray Comp Harness Assy for continuity. Disconnect J420 from the Feeder Board. Disconnect J4202 from the Paper Path Sensor. Is each cable of J420 <=> J4202 continuous? Go to step 4. Replace the Tray Comp Harness Assy. 4 Check the power to the Paper Path Sensor. Disconnect J420 from the Feeder Board. Is the voltage across P420-6 <=> ground on the Feeder Board, about +3.3 VDC? Replace the Optional Feeder. Replace the MCU Board.