Code: 077-100
Description: IOT Regi On early JAM
Causes: • Left Side Harness Assy (PL3.1.18) • Registration Input Actuator (PL3.2.11) • Registration Sensor (Sensor Photo) (PL3.2.13) • MCU Board (SFP PL8.2.13; MFP PL8.3.6) • Feeder Assy. (PL 3.1.98) • Drive Clutch Assy. (PL 3.1.97)
Remedy: 1 Check the error. Replace to known good paper. Does the error still occur when printing? Go to step 2. Complete. 2 Open the Front Cover and check the Registration Rollers. Is the metal roller pressed against the rubber roller by the spring pressure? Go to step 3. Replace Feeder Assy. 3 Perform the first part of the procedure “Registration Clutch” on page 4-33 to check the Registration Clutch. Do you hear a click when the clutch is energized? Go to step 4. Replace the Drive Clutch Assy. 4 Perform the procedure “Registration Sensor” on page 4-22 to check operation of the Registration Sensor. Does the number on the screen increase by one when you operate the actuator? Replace the MCU Board. Go to step 5. 5 Check the connections between the MCU Board and Registration Sensor. Are P/J23 and P/J232 connected correctly? Go to step 6. Reconnect P/J23 and/or P/J232. 6 Remove the Lower Chute Assembly to check the shape and operation of the Registration Input Actuator (PL3.2.11). Are the shape and operation normal? Go to step 7. Reseat the Registration Input Actuator. If broken or deformed, replace it. 7 Check the Left Side Harness Assy for continuity. Disconnect J23 from the MCU Board and J232 from the Registration Sensor. Is each cable of J23 <=> J232 continuous? Go to step 8. Replace the Left Side Harness Assy. (PL 3.1.18) 8 Check the power to the Registration Sensor. Disconnect J23 from the MCU Board. Is the voltage across P23-3 <=> ground on the MCU Board, about +3.3 VDC? Go to step 9. Replace the MCU Board. 9 Remove the Lower Chute Assembly (PL3.2.27) to check the operation of the Registration Sensor. Check the voltage across J23-5 <=> ground on the MCU Board. Does the voltage change, when you operate the Registration Input Actuator? Replace the MCU Board. Replace the Registration Sensor