Code: 077-900
Description: IOT Exit JAM
Causes: • Fuser Assy (PL6.1.1) • Fuser Harness Assy (PL6.1.2) • MCU Board (SFP PL8.2.13; MFP PL8.3.6)
Remedy: 1 Check paper feeding Was paper fed from the Manual Feed slot? Go to step 2. Go to step 4. 2 Was the paper inserted straight into the Manual Feed slot and not at an angle? Go to step 4. Insert paper straight into the Manual Feed slot, and go to step 3. 3 Does the error still occur when printing? Go to step 4. Complete. 4 Check the paper condition Is the paper wrinkled or damaged? Replace with new, dry paper, then go to step 5. Go to step 6. 5 Does the error still occur when printing? Go to step 7. Complete. 6 Reload with new paper. Does the error still occur when printing? Go to step 7. Complete. 7 Open and close the Front Cover, and then latch correctly. Does the error still occur when printing? Go to step 8. Complete. 8 Check the Fuser Assy Does any paper and/or foreign substance remain in the Fuser Assy? Remove the paper and/or substance, then go to step 9. Go to step 9. 9 Reseat the Fuser Assy. Does the error still occur when printing? Go to step 10. Complete. 10 Perform the procedure “Exit Sensor” on page 4-23 to check the Exit Sensor operation. Does the number on the screen increase by one, when you operate the Exit Sensor actuator in the Fuser Assy? Replace the MCU Board. Go to step 11. 11 Check the connections between the MCU Board and Fuser Assy. Are P/J17 and P/J171 connected correctly? Go to step 12. Reconnect the connector(s) P/ J17 and/or P/ J171 correctly. 12 Check the Fuser Harness Assy continuity. Remove the Fuser Assy. Disconnect J17 from the MCU Board. Is each cable of J17 <=> P171 continuous? NOTE: P171 is attached to the frame. Go to step 13. Replace the Fuser Harness Assy. 13 Check the power to the Exit Sensor in the Fuser Assy. Disconnect the connector of J17 on the MCU Board. Is the voltage across J17-1 <=> ground on the MCU Board, about +3.3 VDC? Go to step 14. Replace the MCU Board. 14 Check the Exit Sensor operation. Check the voltage across J17-3 <=> ground on the MCU Board. Does the voltage change, when the actuator of the Exit Sensor is operated? Replace the MCU Board. Replace the Fuser Assy. After replacing the Fuser, be sure to reset the Fuser counter.