Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 077-901 — Xerox WorkCentre 6505

Code: 077-901

Description: IOT Remain Registration JAM
Causes: • Left Side Harness Assy (PL3.1.18) • Registration Input Actuator (PL3.2.11) • Registration Sensor (Sensor Photo) (PL3.2.13) • MCU Board (SFP PL8.2.13; MFP PL8.3.6) • Feeder Assy. (PL 3.1.98) • Drive Clutch Assy. (PL 3.1.97)
Remedy: 1 Check the error. Replace to known good paper. Does the error still occur when printing? Go to step 2. Complete. 2 Open the Front Cover and check the Registration Rollers. Is the metal roller pressed against the rubber roller by the spring pressure? Go to step 3. Replace Feeder Assy. 3 Perform the first part of the procedure “Registration Clutch” on page 4-33 to check the Registration Clutch. Do you hear a click when the clutch is energized? Go to step 4. Replace the Drive Clutch Assy. 4 Perform the procedure “Registration Sensor” on page 4-22 to check the Registration Sensor for operation. Does the number on the screen increase by one when you operate the Registration Input Actuator? Replace the MCU Board. Go to step 5. 5 Remove the Lower Chute Assembly to check the shape and operation of the Registration Input Actuator. Are the shape and operation normal? Go to step 6. Reseat the Registration Input Actuator. If broken or deformed, replace it. 6 Check the connectors of the for connection. Check the connections between the MCU Board and Registration Sensor. Are P/J23 and P/J232 connected correctly? Go to step 7. Reconnect the connector(s) P/ J23 and/or P/ J232 correctly. 7 Check the Left Side Harness Assy for continuity. Disconnect J23 from the MCU Board. Disconnect J232 from the Registration Sensor. Is each cable of J23 <=> J232 continuous? Go to step 8. Replace the Left Side Harness Assy. (PL 3.1.18) 8 Disconnect J23 from the MCU Board and measure the voltage across P23-3 <=> ground on the MCU Board. Is the voltage about +3.3 VDC? Go to step 9. Replace the MCU Board. 9 Check the voltage across P23-5 <=> ground on the MCU Board. Remove the Lower Chute Assembly to check the operation of the Registration Sensor. Does the voltage change when you operate the Registration Input Actuator? Replace the MCU Board. Replace the Registration Sensor

← Xem tất cả mã lỗi Xerox WorkCentre 6505

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie