Causes: • Left Side Harness Assy (PL3.1.18) • Transfer Belt (PL6.1.7) • MCU Board (SFP PL8.2.13; MFP PL8.3.6)
Remedy: 1 Turn OFF the power, and gently wipe the ADC Sensor window with a clean dry cloth or cotton swab. After wiping the window, close the Front Cover. Does the error still occur when the power is turned Off and On? Go to step 2. Complete. 2 Check the connectors between the MCU Board and ADC Sensor. Are P/J28 and P/J281connected correctly? Go to step 4. Reconnect P/J28 and/or P/J281 correctly, then go to step 3. 3 Does the error still occur when the power is turned Off and On? Go to step 4. Complete. 4 Check the Left Side Harness Assy for continuity. Disconnect J28 from the MCU Board. Disconnect J281 from the Transfer Belt. Is each cable of J28 <=> J281 continuous? Go to step 5. Replace the Left Side Harness Assy. (PL 3.1.18) 5 Is surface of the Transfer Belt dirty? Clean the belt with a clean dry cloth, then go to step 6. Go to step 7. 6 Does the error still occur when the power is turned Off and On? Go to step 7. Complete. 7 Replace the Transfer Belt. Does the error still occur when the power is turned Off and On? Replace the MCU Board. Complete.