Remedy: 1 Reseat the Toner Cartridge (Y, M, C or K). Does the error still occur when the power is turned Off and On? Go to step 2. Complete. 2 Check the connections between the MCU Board and CRUM Connector (Y, M, C or K). Are P/J31 and P/J311(Y) / P/J312 (M) / P/J313(C) / P/J314 (K) seated securely? Go to step 4. Reseat the connector(s) securely, then go to step 3. 3 Does the error still occur when the power is turned Off and On? Go to step 4. Complete. 4 Check the Toner CRUM Harness Assy for continuity. Disconnect P/J11 from the MCU Board. Disconnect P/J311(Y) / P/J312 (M) / P/ J313(C) / P/J314 (K) from the CRUM Connector (YMCK). Is each cable of P/J31 <=> P/J311(Y) / P/J312 (M) / P/ J313(C) / P/J314 (K) continuous? Go to step 5. Replace the Toner CRUM Harness Assy. 5 Check the output power of CRUM Connector (Y, M, C or K). Disconnect P/J31 on the MCU Board. Is the voltage across ground <=> J31-3(Y), -7(M), -11(C), -15(K) on the MCU Board, about +3.3VDC? Replace the Dispenser Assy. Go to step 6. 6 Replace the Toner Cartridge (Y, M, C or K). Does the error still occur when the power is turned Off and On? Replace the MCU Board Complete.