Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi CF10 — OKI CX1145MFP

Code: CF10

Description: <Undefined error code processing> <Communication module SRAM writing failure>
Remedy: <Undefined error code processing> MJ-1022/1023/1024 1) Is the error recovered when the power of the equipment is turned OFF and then back ON? 2) If not as in step 1, check if the LGC board and IPC board are connected correctly. 3) If the error has still not been recovered in step 2, check if there is any defect in the LGC board, IPC board or finisher control board. If not, replace the LGC board, IPC board or finisher control board.
<Communication module SRAM writing failure> MJ-1101 1) Is the error recovered when the power of the equipment is turned OFF and then back ON? 2) Check if the MJ-1101 (08-1912) is set as the specified finisher on the equipment. 3) Check if the harness connecting the converter PC board and the finisher controller PC board is disconnected or open circuited. 4) Check if the conductor pattern on the converter PC board is open circuited or short circuited. 5) Check if the conductor pattern on the finisher controller PC board is open circuited or short circuited. 6) Try to update the finisher firmware again. 7) Replace the converter PC board. 8) Replace the finisher control PC board.
MJ-1101 (when MJ-6101 is connected) 1) Is the error recovered when the power of the equipment is turned OFF and then back ON? 2) Check if the MJ-1101 (08-1912) is set as the specified finisher on the equipment. 3) Check if the harness connecting the converter PC board and the finisher controller PC board is disconnected or open circuited. 4) Check if the harness connecting the hole punch control PC board and the finisher control PC board is disconnected or open circuited. 5) Check if the conductor pattern on the converter PC board is open circuited or short circuited. 6) Check if the conductor pattern on the finisher controller PC board is open circuited or short circuited. 7) Check if the conductor pattern on the hole punch control PC board is open circuited or short circuited. 8) Try to update the finisher firmware again. 9) Replace the converter PC board. 10)Replace the finisher control PC board. 11)Replace the hole punch control PC board.

← Xem tất cả mã lỗi OKI CX1145MFP

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie