Code: C465 ... C468
Description: [C465/C466/C467/C468] Pressure roller thermistor abnormality after entering ready status
Causes: Power supply unit LGC board
Remedy: Pressure roller thermistor • Connector check • Check if the pressure roller center/rear thermistor is installed properly. • Check if the harnesses of the pressure roller center and rear thermistors are open circuited. Power supply unit and fuser unit • Check if the fuser unit is installed properly. • Check if the pressure roller lamp is open circuited. (Check if the pressure roller lamp has electric continuity.) • Check if the connector of the pressure roller lamp is disconnected. • Check if the thermistor is open circuited. • Check if the connectors of the power supply (CN404, CN405, CN408, CN409) are disconnected. • Check if the power supply unit is broken. LGC board • Connector check (CN333, CN345, CN361) • Check if the conductor pattern on the board is short circuited or open circuited. Status counter Change the current status counter value (08-2002) "5", "6", "8", "18", "20", "26", "28", "33" or "34" to "0" • The status counter value is set as follows in the following cases. • The error occurred during warming-up: "5" or "6" • The error occurred after the equipment has become ready: "33" • Regardless of the equipment’s status (i.e. during warmingup, printing, paper jam or in ready status), when the temperature detected by the pressure roller thermistor is 210°C or higher: "8", "18", "20", "26" or "28". • The error occurred during printing: "34"