Code: CB10
Description: Entrance motor abnormality. Entrance motor abnormality: The entrance motor is not rotating normally
Causes: Entrance motor (M1) Finisher controller PC board
Entrance motor Finisher control PC board
Entrance motor Finisher control PC board
Remedy: MJ-1101 Entrance roller If there is mechanical problem when the entrance roller is rotated, fix the mechanism. Entrance motor (M1) Check the connectors and harnesses between the entrance motor (M1) and the finisher control PC board (CN7).
MJ-1106 Feeding roller Rotate the feeding roller. Fix any mechanical problem. Entrance motor Check if the connector (CN26) on the finisher controller PC board is disconnected from the entrance motor (M1) and the harnesses are open circuited. Correct if so.
MJ-1106 Feeding roller Rotate the feeding roller. Fix any mechanical problem. Entrance motor Check if the connector (CN26) on the finisher controller PC board is disconnected from the entrance motor (M1) and the harnesses are open circuited. Correct if so.