Code: 123
Description: Humidity sensor error (error code 123)
Remedy: (18-1-1) Check the system connection Connection to the CU/PU board and to the toner sensor board Check if the 20-conductor FFC is connected to the SSNS connector of the CU/PU board normally. Check if the 20-conductor FFC is connected to the CN1 connector of the 76E board normally. Check if the connector is connected in the half-way only or not, and check if the connector is inserted in a slanted angle or not. Re-connect the cable normally. Check if any peeling-off of sheath has occurred or not throughout the cable. Replace the FFC with the normal FFC. (18-1-2) Environment condition Sharp change of environment condition Is the environment condition changed sharply from a low temperature environment to a high environment condition within a short time? (Example is such a case that a printer is moved from storage condition of a cold area in winter to an office environment.) Leave a printer for around one hour in the new environment to get used to the new environment. After that, turn on the power again. Before turn on the power, touch the metal panel of the controller panel and the metal plate inside a printer to feel temperature increase inside a printer with human hands. After confirmation that the printer temperature has increased close to the room temperature, turn on the power again.