Causes: 3003 Check performed when HDD is installed: • HDD device busy for over 31 s. • After a diagnostic command is set for Sthe HDD, but the device remains busy for over 6 s. A diagnostic command is issued to the HDD device but the result is an error • HDD defective • HDD harness disconnected, defective • Controller board defective 3004 No response to the selfdiagnostic command from the ASIC to the HDDs • HDD defective 3013 Mandolin does not respond, the HDD device remains BUSY for more than 31 s, or the BUSY signal does not drop within 6 s after the diagnostic command is issued to the HDDs. • HDD defective • HDD connector loose or defective • Controller defective 3014 Error returned from HDD in response to the self-diagnostic command, Mandolin could not be located due to a read/write error at the HDD register. • HDD defective