Code: SC400
Description: Image transfer belt bias error - Timing - While the image transfer belt bias is ON - Condition - The feedback voltage is 4.8V or higher, or PWM value is 50% or higher for 500ms continuously.
Causes: • Poor connection of connectors • Defective high voltage supply board (T1/PCC/BR) • Defective I/O control board • Defective main control board
Remedy: 1. Check if the connectors of high voltage cable and trigger lines are properly connected on the high voltage supply board, I/O control board, and main control board. 2. Replace the high voltage supply board (T1/PCC/BR). 3. Replace the I/O control board. 4. Replace the main control board. [ Signal Check ] • Feedback signal: CN209-9, TP264, or CN211-A4 on I/O control board / CN302-A6 or TP106 on main control board. • PWM: CN209-10 or TP272 on I/O control board.