Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi SC130 — Ricoh A259 Aficio Color 4006 Lilac

Code: SC130

Description: Scanner start error - Timing - • Scanning start • While the scanner motor is running - Condition - The scanning start signal is generated while the motor is moving. Total number of steps calculated based on the signal from the stepper motor is out of range. The H.P. sensor stays off when the scanner starts moving. A ‘scan start’ command was issued while the motor was active.
Causes: • Scanner motor out of synchronization (drive error) • Poor connection of connectors • Defective scanner HP sensor • Defective scanner IPU board • Defective main control board
Remedy: 1. In SP 5-804-104, stop supplying the current to the scanner motor. Check the output signal from the scanner H.P. sensor in SP 5-803-100 by moving the scanner manually. (0: Not actuated; 1: Actuated - at H.P.) 2. If the result of step 1 is OK; 1 Check the tension of the timing belt. 2 Check if the pulley is firmly secured. 3 Check if the scanner wire is properly wired 4 Check the connection of CN710, and CN731 on the scanner motor drive board. 5 Check continuity of cables. 6 Replace the scanner motor drive board. 7 Replace the scanner motor. 3. If the result of step 1 is not OK; 1 Check if the cable is properly connected. 2 Check the continuity of cable. 3 Replace the sensor. 4 Replace the scanner IPU board. 5 Replace the main control board. - Signals to Check - • Scanner HP: CN406-7 on scanner IPU board or Replace the sub and/or main scanner IPU board(s).

← Xem tất cả mã lỗi Ricoh A259 Aficio Color 4006 Lilac

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie