Code: SC452
Description: Transfer belt mark detection error - Timing & Condition- The main control board does not receive the belt mark detection signal from the transfer belt home position sensor for a certain period.
Causes: • Dirty or damaged belt mark • Belt mark out of position • Defective sensor • Defective I/O control board • Defective main control board
Remedy: 1. Check if the transfer belt release lever is properly set. 2. Clean the belt mark if it is dirty. 3. Replace the transfer belt if a belt mark has peeled off or is damaged. 4. Clean the transfer belt home position sensor if it is dirty. 5. Replace the transfer belt home position sensor. 6. Replace the I/O control board. 7. Replace the main control board. - Signals to Check - • Sensor: CN223-A6, TP210, or CN218-B11 on I/O control board / CN303-B1 or TP137 on the main control board.