Code: SC401
Description: Image transfer belt motor lock - Timing & Condition - • The feedback signal from the motor is still out of range 2 seconds after the trigger signal is sent. • The feedback signal becomes out of range for 2 seconds while the trigger signal is ON.
Causes: • Defective image transfer belt motor • Defective image transfer belt motor drive board • Mechanical problem (drive transmission)
Remedy: 1. Check if the connectors on the image transfer belt drive board (CN740 and 741) and I/O control board (CN220) are properly connected. 2. Check the harnesses are damaged. 3. Replace the image transfer belt motor control board. 4. Replace image transfer belt motor. 5. Check if anything causes the load of the belt motor to be increased. [ Signal Check ] • Motor OK: CN220-A2 or TP153 on the I/O control board