Description: Fusing thermopile cannot reload (low power) This SC is detected if the temperature does not reach the reload permit temperature (center) after passing eight seconds when: • The machine starts warming up. • The machine returns from energy saver mode. • The fusing lamp is activated.
Causes: • Dirty or defective thermopile lenses • Input voltage out of specification (out of warranty) • Fuse blown out.
Remedy: 1. Check the power supply voltage (change the power cord). 2. Replace the fusing thermostat. 3. Replace the fusing lamp. 4. Replace the fusing thermopile. 5. Replace the BiCU. 6. Replace the AC controller board.