Code: 120-00
Description: Scanner home position error 1
Causes: • The scanner home position sensor does not go OFF even if the scanner moves 30 mm at homing. • The scanner home position sensor does not go OFF even if the scanner moves 13 mm at the white balance adjustment. • The scanner home position sensor goes ON before the scanner reaches the specified position (in the sensor OFF area) at returning from the scanning position. • This SC is issued only when the error signal of the scanner HP sensor is detected three times consecutively to prevent the sensor detection error due to some noise. • Motor driver defective • Motor defective • Scanner HP sensor defective • Harness defective • Timing belt, pulley, wire, or carriage not installed correctly
Remedy: 1. Perform the following operations. • Check the harness. • Check the timing belt, pulley, wire, or carriage installation. 2. Replace the following parts. • Replace the scanner motor. • Replace the scanner HP sensor.