Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi SC723-44 — Ricoh D250 MP3054 Cor-C1

Code: SC723-44

Description: Stapler Motor Error (Internal Finisher: Non-Staple Bind) When the stapler drive HP sensor was not turned off while predetermined seconds applied to the stapler motor with the HP sensor turned on. When stapler drive HP sensor was not turned on while predetermined seconds applied to the stapler motor with the HP sensor turned off. The STM driver error detection is started after reset, and predetermined seconds error signal is detected. This SC will be issued when the above phenomenon repeated 2 times.
Causes: • Stapler Motor failure • Connector disconnected • Stapler Motor overload • Stapler HP sensor error • Harness short-circuit • Circuit board failure • Excess current • Abnormal temperature
Remedy: • Check the connection • Replace the motor/sensor • Replace the harness • Replace the circuit board

← Xem tất cả mã lỗi Ricoh D250 MP3054 Cor-C1

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie