Code: E061-0001
Description: Potential control error (VL). The measured value in the dark area (VL) differs +/-30V or higher than the target potential at potential control. MEMO: If the difference is somewhere between +/-10V and less than 30V, alarm is indicated.
Remedy: 1. Check the connection of the Pre-exposure LED (connector connection, open circuit, the caught cable). 2. Check the installation of the Primary Charging Assembly (connector connection, open circuit, the caught cable). 3. Check the fixation state of the Drum and the Drum Shaft. (Check if the drum fixation cylinder is properly installed.) 4. Check if the Dustproof Glass is soiled. If necessary, clean it. 5. Check the installation of the Laser Scanner Unit (connector connection, open circuit, the caught cable). 6. Check the installation of the Primary Charging High Voltage PCB (PCB11), and its connection (connector connection, open circuit, the caught cable). 7. Check the installation of the Potential Sensor (connector connection, open circuit, the caught cable). 8. Check the installation of the Drum Motor (M1), and its connection (connector connection, open circuit, the caught cable). 9. Replace the parts. Primary Charging Assembly Laser Scanner Unit Potential Sensor Primary Charging High Voltage PCB (PCB11) Drum Motor (M1) Main Driver PCB (PCB2) DC Controller PCB (PCB1)