Description: Card Reader communication error
Although communication with the Card Reader was possible at startup, it became unavailable in the middle of the communication.
Remedy: - Harness between the Card Reader and the Main Controller PCB (UN81/J20) - Card Reader [Points to note at work] When checking the harness/cable or connector, perform the following work. 1. Disconnect and then connect the connector to check that there is no bent pin and cable disconnection. 2. Visually check that the harness is not caught or open circuit. 3. If there is any error, replace the corresponding harness/cable. [Remedy] Perform the following in the order while checking whether the error is cleared. 1. Check the cable between the Card Reader and the Main Controller PCB. 2. After removing the Card Reader, execute “COPIER> FUNCTION> CLEAR> CARD” and “ERR”. [Caution] Data related to card ID (department) is cleared.