Code: E602-0001
Description: Error in HDD. HDD failed to be recognized. Startup partition (BOOTDEV) failed to be found at startup.
Remedy: 1. Turn OFF the main switch and check connection of HDD cable, and then turn ON the main switch. 2. If the Encryption Board has been installed, there may be an Encryption Board failure. In this case, disconnect the signal cable connecting to the Encryption Board and directly connect to the HDD. (It cannot be connected from the back side. Open the Main Controller Cover, and connect by going over the Main Controller PCB 1.) After connecting, power on by the safe mode. If the machine starts normally, replace the Encryption Board as the Encryption Board had failed. 3. Be sure that HDD spins stably (no problem in drive sound) and 5V/12V power is supplied when the main power is turned ON. (If the drive sound is abnormal, replace the HDD.) 4. Replace the HDD and reinstall the system. (In the case of using a USB memory device, insert a USB memory device where the system software has been registered to the slot of the host machine, and then execute main menu [3]: Upgrade (Overwrite all).) 5. Replace the Main Controller PCB 1.