Code: E012-0502
Description: A.ITB Drive Roller Speed Detection PCB 1 signal error (Controller Version 2x.xx or later) B.ITB drive motor error (Prior to Controller Version 1x.xx). A.The signal is not detected for 80msec or more. B.Lock signal of ITB drive motor (M3) cannot be detected for the specified time after first detection - Connector disconnected, Breaking (Breaking (shorting)) - Drum (unit) Y/M/C/K not inserted - Peeling of the ITB cleaning blade - Encoder Y/M/C/K failure (This occurs in rare cases.)
Remedy: A: 1. Check the connection of the ITB Drive Roller Speed Detection PCB 1 (UN16). Sensor side: J7318, J7319, J8047 PCB side: J1912 2. Take out the ITB Drive Roller Speed Detection PCB 1 (UN16) to clean. 4. Replace the ITB Drive Roller Speed Detection PCB 1 (UN16). 5. Check if the Harness of the ITB Drive Roller Speed Detection PCB 1 (UN16) is faulty. (Replace the Harness if it's disconnected.) 6. Replace the Drum ITB Driver PCB (UN6). B: Check the connection between the ITB driver motor (M3) and the drum ITB driver PCB (UN6). (Connection of the connector, Breaking (Breaking (shorting))) Motor side: J7518, J8047, J8050 PCB side: J1921, J8011, J8050 2. Check the connection of the ITB drive roller speed detection PCB 1/2 (UN16/17). (Connection of the connector, Breaking (Breaking (shorting))) Motor side: J7318, J7319, J8047, J8050 PCB side: J1921, J8011, J8050 3. Reinstall the 4 color drum units. (If the drum unit is not installed properly, more load is applied to ITB drive.) 4. Replace the drum unit. (Drum drive may be overloaded due to peeling of the blade, etc.) There may be cause in each color. 5. Replace the drum ITB driver PCB (UN6).