Code: E531-8002
Description: Staple Motor (M9) error
After execution of staple operation, the motor was operated in the positive direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46 seconds. Then, the motor was rotated in the negative direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46sec.
After execution of staple operation, the motor was operated in the positive direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46 seconds. Then, the motor was rotated in the negative direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46sec.
Remedy: 1. Check the connector connection of the Staple Unit. 2. Disconnect the Harness of the Staple Unit. 3. Replace the Staple Unit. 4. Replace the Finisher Controller PCB.