Code: E530
Description: The rear aligning plate does not reach home position when the rear alignment motor (M4) has been driven for a specific time.
The rear aligning plate does not reach home position when the rear alignment motor (M4) has been driven for a specific time.
The rear aligning plate does not reach home position when the rear alignment motor (M4) has been driven for a specific time.
Causes: The rear alignment motor (M4) is faulty. The rear aligning plate home position sensor (S7) is faulty. The sensor connector is disconnected or has an open circuit. The rear alignment motor relay harness is faulty. The rear aligning plate is subjected to an abnormal load. The finisher controller PCB is faulty.
Remedy: 1) Rear aligning plate home position sensor (S7) Check the rear aligning plate home position sensor (S7). Is the sensor normal? NO : Replace the sensor. 2) Wiring List the wiring between the finisher controller PCB and the rear alignment motor (M4). NO : Correct the wiring. 3) Rear aligning plate Is the rack riding cover the collar of the roll? YES : Correct it. 4) Rear alignment motor (M4), Finisher controller PCB Try replacing the rear alignment motor (M4). Is the fault corrected? YES : End. NO : Replace the finisher controller PCB.