Code: E040
Description: The holding lifter (multifeeder) is faulty
• When the multifeeder is selected, the holding plate position sensor (PS1302) does not detect the holding plate despite the holding plate solenoid (SL2) activation signal from the DC controller PCB.
• When the multifeeder is selected, the holding plate position sensor (PS1302) does not detect the holding plate despite the holding plate solenoid (SL2) activation signal from the DC controller PCB.
Remedy: Holding plate drive assembly 1) Is there any damaged part in the holding plate drive assembly? YES: Replace any damaged part. Holding plate position sensor 2) Check the condition of the sensor using the printer driver checker. Is the result good? NO: Replace the multifeeder tray PCB. Holding plate solenoid, DC controller PCB 3) Disconnect connector J1302 of the holding plate solenoid, and measure the resistance between connectors J1302-1 and J1302-2 on the harness side. Is the resistance about 100 Ohm NO: Replace the holding plate solenoid. YES: Replace the DC controller PCB.