Code: SC351
Description: ID Sensor Error 2
One of the following conditions were detected when checking the ID sensor pattern: 1) Vsg <= 2.5 V 2) Vsg = 0 V 3) The ID sensor output voltage = 5.0 V and PWM signal input to ID sensor = 0 Vsg is the ID sensor output after checking the erased drum surface NOTE: 1) Vsp is the ID sensor output after checking the ID sensor pattern image. 2) The SC code is not displayed; only the logging data is incremented. 5) Regarding toner supply, if an abnormal condition is detected, then only the toner density sensor output is used, without an updated Vref setting. 6) After an abnormal condition is detected, SP3103 (ID Sensor Output Display) shows Vsp = Vsg (or 5.0V).
One of the following conditions were detected when checking the ID sensor pattern: 1) Vsg <= 2.5 V 2) Vsg = 0 V 3) The ID sensor output voltage = 5.0 V and PWM signal input to ID sensor = 0 Vsg is the ID sensor output after checking the erased drum surface NOTE: 1) Vsp is the ID sensor output after checking the ID sensor pattern image. 2) The SC code is not displayed; only the logging data is incremented. 5) Regarding toner supply, if an abnormal condition is detected, then only the toner density sensor output is used, without an updated Vref setting. 6) After an abnormal condition is detected, SP3103 (ID Sensor Output Display) shows Vsp = Vsg (or 5.0V).
Causes: • ID sensor defective • ID sensor harness defective • ID sensor connector defective • IOB defective • LD unit defective • BCU defective • CBG power pack defective • Dirty ID sensor