Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 948.xx, 949.xx — Lexmark X204

Code: 948.xx, 949.xx

Description: Failed controller board
Remedy: Replace the controller board. Controller card assembly Verify +24 V dc input from the LVPS/HVPS. • Turn the MFP off. • Disconnect the LVPS/HVPS cable from the controller card at J22. See “Controller card” for more information. • Turn the MFP on. Verify +24 V dc from the cable connector of J22, pins 8 and 9. Verify that pins 7, 12, and 14 on both the cable and the card connectors are ground. • If voltage is correct, check the continuity in the cable. If the cable is good, see the “Controller card” for more information. • If grounds are not correct on the cable, first check it for continuity and then check the LVPS/HVPS. See “LVPS/HVPS service check” • If the grounds are not correct on the controller card, replace the controller card. (Check with one probe on the connector pin and the other on the ground plane of the card found at each screw head.) Note: With all cables connected, the MFP should complete POST within approximately 12–15 seconds in the following sequence: 1. The function and scan quality LEDs illuminate for one second and then flash three times. 2. Loading is displayed on the operator panel. 3. The CIS illuminates, and the scanner performs a calibration. 4. The drive motor runs. 5. The scanner CIS returns to the home position. 6. Error messages are displayed if applicable. 7. The MFP cycles down into standby mode/ready. Ready is displayed on the operator panel. If immediately following power-on, the operator panel lights are active but the MFP does not go through steps 1 and 2 above, replace the controller card assembly.

← Xem tất cả mã lỗi Lexmark X204

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie