Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 948.xx, 949.xx — Lexmark X364

Code: 948.xx, 949.xx

Description: Failed engine board
Remedy: Replace the controller board.
Warning: Do not replace the operator panel and controller board at the same time. Each card contains the printer settings. When either of these cards is new, it obtains some of the settings from the other card. Settings are lost when both are new and replaced at the same time. POST (Power-On Self Test) Note: The printer should complete POST in approximately 30 seconds. If the printer fails to display lights or activate the drive motor, fuser, or fan, then check the following order: 1.Power to the LVPS/HVPS 2.Power from the LVPS/HVPS to the controller board 3.Cables are plugged in correctly, especially for the operator panel. The printer will not power-up without a functioning operator panel. 4.The controller board assembly. The LED adjacent to J12 will be illuminated if the card is powered and good. 5.The operator panel. See “Operator panel service check”. Verify +24 V dc input from the LVPS/HVPS. 1.Turn the printer off. 2.Disconnect the LVPS/HVPS cable from the controller board at J22. 3.Turn the printer on. 4.Verify +24 V dc on positions 6, 17, and 19 of the cable connector (LVPS/HVPS). 5.If voltage is correct, then check the continuity in the other conductors of the cable. If the cable is good, then turn the printer off, and check the connectors to the controller board. 6.Verify that pins 10, 12, 14, 16, and 18 on both the cable and the card connector are grounded. 7.If grounds are not correct on the cable, but the cable passes continuity otherwise, then check the LVPS/HVPS. 8.If the grounds are not correct on the controller board, then replace the controller board. (Check with one probe on the connector pin and the other on the card’s ground plane found at each screw head.) Controller board voltage outputs Turn the printer off, and plug the LVPS/HVPS cable into J22 of the controller board. See the wiring diagram at the end of the manual which identifies the output voltages and grounds for a good controller board. Turn the printer off before plugging or unplugging any connectors.

← Xem tất cả mã lỗi Lexmark X364

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie