Description: The video never started on the page at the input sensor within two inches after hitting the input sensor
Remedy: Printhead Note: New printhead must be aligned. See “Printhead assembly electronic adjustment”. Turn the printer off. Disconnect the printhead cables from J12 and J8 on the controller board. Turn the printer on with the front door closed. On the controller board, verify +5 V dc on pin 10 at J12 and +5 V dc on pins 1, 2, and 3 at J8. Verify grounds on pins 2, 4, and 7 at J12 and on pin 4 at J8. •If voltages or grounds are incorrect, then check the controller board. See “Controller board service check” for more information. •If voltages are correct, then replace the printhead (comes with cables).