Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 292.00, 293.02 — Lexmark X364dw

Code: 292.00, 293.02

Description: 292.00 Scanner jam, remove all originals from the scanner. This message appears if the ADF cover is open while paper is fed through the ADF. 293.02 Flatbed cover open. The MFP senses that the flatbed cover is open.
Remedy: 1 Is the ADF cover properly closed? Go to step 3. Go to step 2. 2 Close the ADF cover. Does the problem go away? Issue resolved Go to step 3. 3 Perform the ADF cover open sensor test. See “Scanner Tests”. Does the sensor work properly? Go to step 4 Go to step 8. 4 On the bottom of the ADF cover, inspect the ADF cover closed sensor actuator. Does it move freely? Go to step 6. Go to step 5. 5 Fix the actuator so it moves freely. Does this fix the problem? Issue resolved. Go to step 6. 6 Remove the ADF rear cover and inspect the ADF cover closed sensor for dirt and debris. Is there dirt and debris present? Go to step 7. Go to step 8. 7 Clean the dirt and debris from the sensor. Does this fix the issue? Issue resolved. Go to step 8. 8 Inspect the connections on the ADF relay card in the ADF. Are all the connections properly connected? Go to step 9. Secure all the connections. 9 Check the ADF cable for continuity. Is there continuity? Go to step 10. Replace the ADF cable. See “ADF cable removal”. 10 Check for signals or voltages from J4 on the controller board. Pin 11 and 12 should measure +24VDC. Pin 5 should measure +14VDC. Are there signals or voltages present? Replace the ADF. See “ADF removal”. Replace the controller board. See “Controller board removal”.

← Xem tất cả mã lỗi Lexmark X364dw

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie